HK 3700
Harman Kardon® HK 3700 stereo receiver
Getting started with your HK 3700
Documents & Downloads
Specifications
- Power Consumption
- less than 0.5W (standby)
- Power per channel
- 85 watts per channel, two channels driven @ 6/8 ohms, 20Hz – 20kHz, less than 0.07% THD
- Input Sensitivity/Impedance
- 250mV/27k ohms
- Signal-to-Noise Ratio (IHF-A)
- 100dB
- Frequency Response (@ 1W)
- 10Hz – 130kHz (+0dB/–3dB)
- Height (in)
- 4-3/4
- Height (mm)
- 121
- Width (in)
- 17-5/16
- Width (mm)
- 440
- Depth (in)
- 11-13/16
- Depth (mm)
- 300
- Power Requirement
- 120V AC/ 60Hz (USA); 220V-240V AC 50Hz/60Hz (EU)
High-performance 170 watt stereo receiver with analog & digital capacity and networked connectivity.
Højtydende stereoreceiver med 170 watt effekt, analog og digital kapacitet samt tilslutningsmuligheder via netværk. Harman Kardons ry for fremragende lydkvalitet og effekt uden forvrængning er netop nået et nyt niveau, hvor det bedste fra både den digitale og den analoge verden mødes. Oplev 170 watt effekt i en stereoreceiver, der er dedikeret til alle tilslutningsmuligheder for alle dine enheder. Den højtydende Harman Kardon HK 3700 stereo receiver leverer alt, hvad du skal bruge for at drive et hjemmelydsystem. Med analoge og digitale tilslutningsmuligheder leverer HK 3700 masser af effekt og tilbyder en indbygget 192 kHz/24-bit DAC. Opret forbindelse til dit hjemmenetværk via Ethernet, og afspil alt dit lokale indhold over DLNA 1.5, eller tilslut en lagerenhed eller en hvilken som helst Apple iOS-enhed via USB. Og med indbygget AM/FM-radio og grammofonindgang slår HK 3700 på elegant vis bro mellem klassisk og moderne lyd. Det er et utroligt effektivt centrum for dit hjemmelydsystem – en skøn forening mellem kravene fra klassisk lyd og den nye lyds behov for fuld tilslutningsmulighed. Nyd dit nye underholdningshovedkvarter – som vil vække misundelse hos alle, der ser og hører det.
FAQs & How-Tos
-
Please refer to the owner's manual for AVR 151 or 151S. The procedure is explained there. The remote control contains a number of pre-programmed command sets that can be activated to control TV sets, disc players and other devices of various brands.Was this helpful? Thank you for your feedback!
-
There are five possible reasons for the receiver shutting down. 1. There is a problem internally with the receiver. 2. There is a problem with one or more of your speakers. 3. There is a problem with one or more of your speaker wires. 4. There is a problem with the speaker wiring done on your system. 5. The unit is overheating. No ventilation. First, check the wiring at every speaker terminal at the back of your receiver and at the back of your speakers. A single strand of speaker wire crossing from one terminal to another would be enough to cause the amp to shut down or go into PROTECT. If you do not find any problems with any of the wiring, you should disconnect all speakers from your receiver. If the receiver continues to go into PROTECT, the problem is in the receiver. Please submit a case on the Contact Us page. They will be able to assist you. However, if it turns on, the problem is elsewhere. Begin reconnecting one speaker at a time. Eventually you will connect a speaker that will cause the receiver to shut down. At this point you have found your culprit. On the other hand, it may just be overheating. You must have at least 2 - 3 inches of space between the top of the unit and any shelf or component above the unit. The unit should not be inside a sealed compartment when being used. The unit must be able to breath. There are very powerful amps in these receivers. If they run too hot, they will shut down. An external fan can help this.Was this helpful? Thank you for your feedback!
Images & Videos
Can’t find what you’re looking for?
Call us
Call us now at:
+45 32712498
Mandag - Fredag - 09:00 - 17:00
Chat with us
Monday - Friday: 09.00-18.00
Saturday - Sunday: 11:00-16:00